Actuator Installation - Seltron MP15 Mode D'emploi

Actuator installation

Picture 5
1. In case of mounting the actuator on Seltron mixing valves, example 1,
loosen the plug 1a and fit it in the upper right position on valve flange. In
case of mounting the actuator on other mixing valves, example 2, use the
enclosed plug A1 or A2 and fit it in the upper right position on valve flange.
2. Put the plug B on the shaft of mixing valve. Point the plug
arrow to the middle of the valve position indication plate.
3. Put the actuator C on plug B and fasten it with the screw E.
4. Put the indicator plate F onto the knob D.
5. Do the wiring connections as shown on pictures 6a, 6b, 6c and 6d.
Installation manual
3