Mixing Smoothies; Preparing Ingredients And Filling The Container - ADE Smoothie Mode D'emploi

Mixing smoothies

Mixing smoothies

Preparing ingredients and filling the container

WARNING against injury
− The blades on the blade attachment are sharp. Be careful when
handling them!
NOTE on material damage
− Do not overfill the drink bottle or drink container.
− Do not fill the drink bottle or drink container with hot liquids.
− To make "crushed ice", fill the drink bottle or drink container at
the most one third full with ice cubes. Add approximately two
tablespoons of water. Do not crush ice without adding liquid.
− To avoid damaging the blade attachment when making "crushed ice",
press the on/off switch repeatedly in quick succession. Take the drink
bottle or drink container from the base unit and shake the contents to
mix them up better and then re-mix the contents.
1. Peel and de-seed the fruit or vegetables.
Use only soft, fresh fruit or vegetables.
2. Cut the food into evenly small pieces (approx. 1-2 cm).
16
3. Put the preprocessed food in the drink
bottle or drink container until it is
half-full.
Put softer fruits and vegetables on top.
Then they will be the first to be blended
when the container is attached. This
results in a better mixing. Fill another
half of the container with liquid.
4. Pay attention to the measuring scale of
the bottle. Apple or orange juice, milk
or yoghurt can be used as liquids.
KA 1805-1 "smoothie" accessory set