Sangean RCR-3 Mode D'emploi page 9

Radio operation
Tuning into radio stations
There are 3 ways of tuning your radio:
A. Manual tuning
1. Press the Power button to turn on your radio.
2. Press the BAND button repeatedly to select AM (MW) or
FM waveband.
3. Press the TUNING up or down button to change the frequency.
4. Press the Power button again to turn off your radio.
B. Scan tuning
1. Press the Power button to turn on your radio.
2. Press the BAND button repeatedly to select AM (MW) or
FM waveband.
3. Press the TUNING up or down button for more 0.5 second
and release, it will tune into the next frequency with reception.
4. Press the Power button again to turn off your radio.
C. Presetting and recalling stations
Presetting stations:
1. Press the Power button to turn on your radio.
2. Press the BAND button repeatedly to select AM (MW) or
FM waveband.
3. Tune into the station that you would like to preset.
4. There are 7 preset buttons from 1 to 7. Press 1 of them and
hold for more than 2 seconds until the radio beeps, and the
station frequency will be saved into the chosen preset.
5. Repeat the procedure for the remaining presets. Your radio has
7 presets for each AM and FM.
6. The preset can be overwritten by following the above procedure.
Recalling stations:
1. Press the BAND button for AM or FM.
2. Simply press 1 of the PRESET buttons (from 1 to 7) you would
like to tune into. And the preset number and frequency will
appear on the display.
GB
8