Sangean RCR-3 Mode D'emploi page 10

Alarm operation
There are 4 alarms which can be set independently. Alarm 1 and
Alarm 2 can be set to wake you by buzzer, and Alarm 3 and Alarm
4 can be set with radio alarm. When the alarm light is on, it means
the indicated alarm will active in 24 hours.
How to set Buzzer Alarm (Alarm 1 and Alarm 2)
The buzzer beep increases in volume every 15 seconds. It beeps
1 minute, followed by 1 minute silence and repeat the cycle.
The buzzer will beep for 1 hour, or stop by pressing the
Power button.
The buzzer alarm volume may be adjusted through the Alarm sound
level control button on the bottom of the radio.
1. Press the Alarm 1 (or Alarm 2) button and Alarm 1 time
(or Alarm 2) time will show on the display.
2. Press the SET button, the alarm hour will show on the display.
3. Press TUNING up or down button to adjust the hour.
4. Press the SET button again and adjust the minute by pressing
TUNING up or down button.
5. Select required days of week on which the alarm will beep by
pressing day of week buttons. (press the day buttons again to
deactivate the days)
6. Press the SET button again and press TUNING up or down
button until the mark
7. Press the SET button to complete the setting.
8. When it is buzzing, the
Press the Power button to stop the buzzer. And the
mark will stop blinking.
* You can press the Alarm 1(or Alarm 2) button anytime to complete
the setting.
9
or is shown.
or mark is blinking.
or