HQ Power BEAM TRACKER 150 Mode D'emploi page 4

c) DMX-512 Chain with Termination
A DMX terminator is recommended for installations where the DMX cable has to run a long
distance or is in an electrically noisy environment (e.g. discos). The terminator prevents
corruption of the digital control signal by electrical noise. The DMX terminator is simply an XLR
plug with a 120 resistor between pins 2 and 3, which is then plugged into the XLR output
socket of the last device in the chain. Refer to the illustrations on the left.
d) Selecting the Start Address for the DMX Projector
All DMX-controlled devices need a digital start address so that the correct device responds to the signals. This digital
start address is the channel number from which the device starts to "listen" to the digital commands from the DMX
controller. Enter the correct number and read it from the display located on the base of the VDP150OAW8.
You can use the same starting address for a whole group of devices or enter an individual one for every device.
When all devices have the same address, all the units will "listen" to the control signal on one particular channel. In
other words: changing the settings of one channel will affect all devices simultaneously. If you set different
addresses, each device will "listen" to a separate channel number. Changing the settings of one channel will only
affect the device in question.
In the case of the 8-channel VDP150OAW8, you will have to set the start address of the first unit to 1, the second
unit to 9 (8 + 1), the third to 17 (9 + 8), and so on.
e) Function selection
Different functions can be set by means of the 5 push buttons and the display. When you switch the device on, the
display setting will be the same as before you turned it off.
Procedure: • Press the UP or DOWN button to select a different function
• Press ENTER to confirm the selected function ; the display will show "PASS"
• Switch it on or off using UP or EXIT/DN (up=no and down=yes in DMX start address selection mode)
• Press ENTER again to confirm your settings
• Press EXIT/DN to save the setting and exit the menu
Please refer to the list below for the different settings:
Channel
1
2
3
4
5
6
7
8
Function
F5
F6
F7
F8
F9
FA
FB
FC
VDP150OAW8
F1
pan
tilt
pan (16-bit)
tilt (16-bit)
speed
colour
dimmer
shutter
pan
tilt
setup
music control
auto program
master - slave mode
no function
display up/down
F2
pan
pan (16-bit)
tilt
tilt (16-bit)
speed
colour
dimmer
shutter
Corresponding function
N
N
N
N
N
N
N
N
4
F3
pan
tilt
speed
colour
dimmer
shutter
F4
pan
tilt
colour
dimmer
shutter
Y
Y
Y
Y
Y
Y
Y
Y
VELLEMAN