Installing The Electrical Supply Lines - Dometic GROUP WAECO CoolAir RT880 Notice De Montage

CoolAir RT880
7.2.6

Installing the electrical supply lines

!
WARNING!
 The electrical power supply may only be performed by qualified
personnel with specialist knowledge.
 Make sure there is no voltage present on electrically operated
components before carrying out work on them!
A
NOTICE!
 Fit a fuse of 25 amps to the connection to the vehicle's power supply.
 The battery must be able to supply the required current and voltage
(chapter "Technical data" on page 43).
I
NOTE
The unit is equipped as standard with:
 lveco Stralis AS/AT: a 4 m long cable with a cross-section of 6 mm
 lveco Stralis AS³: a 9.5 m long cable with a cross-section of 8 mm
If longer cable lengths are required, then the cable cross-section must
be increased by an authorised specialist workshop:
In this case cut off the cable as closely as possible to the unit
(max. 0.5 m) and then establish a suitable connection with a larger
cable cross-section.
The manufacturer recommends:
 Iveco Stralis AS/AT: when the cable is extended by 4 m to 6 m in
length, use a cross-section of at least 8 mm
 Iveco Stralis AS/AT: when the cable is extended by 9 m to 11 m in
length, use a cross-section of at least 10 mm
lveco Stralis AS/AT:You can connect the unit to the battery via the
lorry's terminal block or directly. The terminal block is to be preferred for
the connection. Ask your vehicle manufacturer for the specifications of
the terminal block.
lveco Stralis AS³:You can connect the unit to the battery via the lorry's
terminal block or directly. Here, the connection directly to the battery
should be preferred, as the consumer which is connected to the terminal
block switches off after approx. 10 min if there is a high power require-
ment.
➤ Lay the supply line and connect it to the vehicle (red line to plus, black
line to minus).
➤ Plug in the supply line plug into the socket of the air conditioning roof
unit supply line.
➤ To relieve strain on the supply line, secure it with a cable tie, e.g. to
the cab roof.
EN
Installation
2
.
2
.
2
2
37