Fitting Onto A Jane Pushchair; Maintenance - JANE MICRO-BB Mode D'emploi

G. FITTING ONTO A JANE PUSHCHAIR
To fasten the carrycot to a Jané chassis, position the carrycot so
that the child's head is at the end opposite the handlebar.
Insert the Profix adaptors into the slots in the chassis armrests,
intended for this; they will click when locked into place.
! TAKE CARE! Before using it, make sure that all the locking
catches are closed.
To detach the carrycot from the chassis, pull the unlocking buttons
on the adaptors upwards and detach the carrycot from the
pushchair by lifting it up.
5b
To prevent the carrycot from rocking, when attaching it to the
pushchair use the fastening system following the instructions.
Adjust the strap to tighten it.
-KENDO, WALKY
6
-MUUM 7
8
-EPIC, RIDER, TRIDER
!
WARNING: Unlock the system before removing the carrycot.
H. MAINTENANCE
Clean the plastic parts with soap and warm water, then carefully dry
all the components.
5
Hand wash at temperature no higher than 30° C. Leave to dry naturally
5a
in a shaded place.
If the upholstery is exposed to sunlight for prolonged periods of time
it may affect the colour of the fabric.
MICRO-BB comes with a guarantee with precise specifications for
correct maintenance, which are important for the guarantee to
remain fully valid.
For your safety and the good conservation of this product, it is
important to bring it to one of our official workshops for regular
inspections.
25
EN