AIRFORCE Integra G5 Prescriptions De Montage Et Mode D'emploi page 55

(Warning: burn hazard!!!) Lastly, clean the cooking zone when it has cooled.
The symbols on the cooking top can wear out as a result of using abrasive or aggressive detergents,
steel wool, and the scraping of pots and pans. Avoid using these cleaning products. In any case,
this will not in any way compromise the unit's correct operation.
Note: all of the problem issues described in this section are solely of an aesthetic nature and do not
in any way affect the appliance's correct operation. They cannot be restored under the warranty.
TABLE OF COOKING TOP ERRORS
These errors appear on the cooking top display.
Error code
flashing
U 400
E2
Er20, Er22, Er31, Er36, Er47,
E5, E6, E9
CLEANING AND MAINTENANCE FUNZIONAMENTO
OPERATION
Description
Continuous activation
of one or more keys. The
control turns off after 10
seconds.
Input current > 300 V.
The control unit shuts
down after 1 second,
emitting a continuous
beep.
Hob overheated.
Problems due to
hardware, software or
power supply.
Possible causes
Liquids or cookware on
the control zones.
Incorrect connection.
Hob overheated
(cooking with empty
pots)
Output heat on sensors
> safety level.
Hardware errors detected
55 55
GB I
Solution
Clean the control zone or
remove the cookware.
Contact the authorized
technical support centre
and specify the error
code.
Cool down the hob; the
error disappears after
cooling.
If the error persists,
contact the authorized
technical support
centre and specify the
error code.
Contact the authorized
technical support centre
and specify the error code.