Sharp AY-XPM7FR Mode D'emploi page 17

TIMER ON
DISPLAY
MODE
1h
CLEAN
FAN
SWING
SET/C
COMBINED USE OF ON AND OFF TIMERS
You can use the ON and OFF timers in combination.
NOTES:
• You cannot programmed the ON-TIMER and OFF-TIMER to operate the unit at different tem-
peratures or other settings.
• Either timer can be programmed to activate prior the other.
1
Press the TIMER ON (
2
The TIMER ON indicator will blink; press the
TIME ADVANCE or REVERSE buttons to
set the desired time. (The time can be set in
10-minute increments.)
3
Point the remote control at the signal receiver
window on the unit and press the TIMER SET
(SET/C) button.
• The orange TIMER lamp (
light.
• The unit will generate a beep when it receives the
1
signal.
4
Select the operation condition.
• If unit(s) is/are operated in one mode while TIMER
2
ON is set with another unit in different mode, the
timer may not activate the required operation.
3
• The unit will turn on prior to the set time to allow
the room to reach the desired temperature by the
programmed time. (Awaking function)
Example:
To stop operation at 11:00 p.m. and resume opera-
tion (With the same mode and temperature set-
tings) to bring the room temperature to the desired
level by 7:00 a.m.
1
Set the TIMER OFF to 11:00 p.m. during opera-
tion.
2
Set the TIMER ON to 7:00 a.m.
The arrow (
cator and the TIMER OFF indicator shows which
timer will activate fi rst.
GB-15
) button.
or ) between the TIMER ON indi-
) on the unit will