Publicité
Les langues disponibles
Les langues disponibles
9.
Insert one Wood Dowel (N) into each of
the pre-drilled holes on the top edges of
the Assembly from step 8. Then locate
Mantel/Top (G) and lay finished side up
on top of completed assembly. From the
inside, attach Mantel/Top (G) using
Bolts (L) and Washers (M) through the
pre-drilled holes in the mounting blocks.
HAND TIGHTEN ONLY.
10. Using Phillips head screwdriver tighten
all Bolts alternating top and bottom, left
and right.
11. Remove the two mounting brackets
attached to the back of the Left and
Right Front panels. Set aside with the
wood screws.
PLEASE READ ALL "ELECTRIC
FIREPLACE INSERT"
INSTRUCTIONS PRIOR TO
INSTALLING ELECTRIC INSERT
IN YOUR COMPLETED
FIREPLACE MANTEL. INSTALL
THE INSERT IN YOUR
FIREPLACE CLOSE TO ITS
FINAL POSITION.
12. Lift insert carefully into the back of the
unit and center in the insert opening. Do
not dr ag insert across Hearth/Base (A) as
it may scratch your unit.
13. Install the mounting brackets to hold
insert flush against the inside of the
mantel front panel.
MOVE YOUR COMPLETED UNIT
ONLY SHORT DISTANCES.
MOVE COMPLETED UNIT WITH
GREAT CARE. IT TAKES TWO
PEOPLE TO MOVE COMPLETED
UNIT INTO ITS FINAL POSITION.
Twin-Star International, Inc.
Delray Beach, FL 33445
In English: 1-866-661-1218
In French: 1-866-374-9203
In Spanish: 1-866-661-1218
Model# 23WM158
Made in China
Printed in China
© 2010, Twin-Star International, Inc.
E-4
Mantel/Top
G
Completed
Assembly
Electric
Fireplace Insert
Completed
Unit
Install
Insert
From
Back
Publicité
