Start Up; Controller Parameter - Ecolab MULTRONIC Manuel Technique

4

Start up

The timer module cannot be configured and the measuring parameters cannot be adjusted.
Only the settings for the biocide metering can be entered under the controller parameters.
4.1

Controller parameter

The main menu of the Multronic can be accessed through operating the ↑-key from the
measuring mask.
Main menu
Select the control parameters through positioning the cursor on the selected item and
operating the ENTER-key.
Control parameter
module selection
The timer module that is to be parametered can now be selected. To do so, move the
cursor onto the correspondingly selected item and operate the ENTER key.
You can set up to seven different times.
You change between the times by pressing ENTER and → (for the next metering time) or
ENTER and ← (for the previous metering time). The cursor must be positioned on one of
NOTE
the selection lines and ENTER must be pressed first. The first row indicates the time that
is currently set.
Timer-control
parameters (page 1)
The time for which a biocide metering process is planned is specified under the item time X.
Value range: 00:00 to 23:59
The metering time indicates the intended duration of this biocide metering procedure.
Value range: 1 min to 600 min
417101824_Anhang13_Timermodul.doc
Timer Modul
- 14 - Rev.: 4-07/10