Operating Instructions - Silhouette Select DIM3225BLSST Guide D'utilisation Et Soins De Propriètaire

Ice Maker Performance Mode Instructions (cont)
Performance
Mode
Drain pump mode. Unnecessary water
will force the drain
out by the pump on
back of the unit.
NOTE:
1. If you take out the bottom board of the ice box, it will make the volume of the ice box larger and
therefor will keep more ice.
2. If your operating using the "Manual drainage system mode", ice will restrict drain water from flowing out.
The Ice Maker should be placed in where the ambient temperature is between 5-35°C (41-95°F). If the ambient
temperature is above or below this range, the performance of the unit may be affected.
CONTROLS OF THE ICE MAKER
Small Med
INSTALLATION INSTRUCTIONS
Instructions Suitable situation
The height of drain
hole in the room is
between
101mm~1500mm

OPERATING INSTRUCTIONS

Large On/Off
Operation instruction
Ref: Fig.A & Fig.B & Fig.C
Screw Nut and Switch
screw nut(front) (3) + seal washer(front)(4)
screw nut(back) (7) + seal washer(back) (6)
screw nut for valve seal (11)
screw nut for valve seal (12)
force water outlet switch (8)
1. Please insure the screw nut and switch are in the
above condition;
2. Use a certain length drain pipe, connect one side to
the force water outlet pipe connector (10), the other to
the drain hole. Please insure the connection is tight to
avoid water leakage.
5
Condition
lock
open
open
lock
on