Silhouette Select DIM3225BLSST Guide D'utilisation Et Soins De Propriètaire page 11

INNER WATER CONTAINER
CLEANING
WARNING
Please follow the steps below only when the ice maker is
disconnected from the power and has no water or else
may cause electric shock or a wet floor board.
1. Ice maker machine cover board
2. Ice maker machine cover plate
3. Ice maker machine
4. Inner water container
Fig A.
1
2
Fig C.
1. Take out the cover board (1) of the ice maker machine (3) press one side of the cover plate (2) and pull out the other
side, then easily take out the cover plate. (Fig.A & Fig.B)
2. Prepare a water tray,take downwords of the water pipe (5) of the inner water container (4) ,then drain the water to the
water tray. (Fig.C)
3. Take down the valve (6) and fixed screw, then clean the valve (7).
4. Use the brush to clean all the parts, then use clean water to flush them.
5. After cleaning, fix the parts on opposite sides.
OPERATING INSTRUCTIONS
5. Water pipe
6. Valve
7. Fixed screw
4
5
NOTE:
• If the unit is unplugged, power lost, or turned off you
must wait 3 to 5 minutes before restarting the unit. If
you attempt to restart before this time delay, the Ice
Maker will not start.
• When you use the Ice Maker for the first time or restart
the Ice Maker after having been shut off for a long time,
there could be a few degrees variance between the
temperature you select and the one indicated on the
LED readout. This is normal and it is due to the length
of the activation time. Once the Ice Maker is running for
a few hours everything will be back to normal.
Fig B.
3
Fig D.
9
7
6