Factory Defaults
Binding
Bind socket
Insert the Bind Plug in the
BIND port on the receiver.
N
TH TRIM
Center the ST TRIM and TH
TH RATE
TRIM dials on the transmitter.
Remove the Bind Plug, then
power off the ESC to save the
OM
TH
ST
R
N
R
ST TRIM
ST TRIM
ST TRIM
ST RATE
TH LIM
50/75/100
OFF
settings.
Connect a fully charged battery
pack to the ESC.
Turn the steering wheel to full
right. Power the transmitter
on while holding the steering
wheel to the right.
Power off the transmitter.
19
ON
Power on the ESC. The red
LED flashes, indicating the
receiver is in bind mode.
Release the steering wheel
when the receiver LED stops
flashing.
WWW.ARRMA-RC.COM