USER'S MANUAL FOR AEROSTAT
1. Introduction
Read this manual completely before you install and put this product into use.
Follow the instructions set out in this manual to ensure proper operation of the product and to
be able to invoke guarantee.
The guarantee terms are stated in the General Conditions for the Sale and Delivery of Products
and/or Performance of Activities by SIMCO (Nederland) B.V.
2. Safety
The Aerostat
®
Sentry is only designed to neutralize static electricity.
Do not use the Aerostat Sentry in fire and/or explosion hazardous environments.
Make sure that the equipment is properly earthed.
Earthing is needed to ensure proper operation and to avoid electrical shocks upon contact.
When carrying out work on the equipment: de-energise the equipment.
Electrical installation and repairs shall be done by a skilled electrical engineer.
Do not put any objects through the outlet grating.
They may get into contact with live parts.
If changes, adjustments, etc. have been made without prior consent in writing, or if no original
parts have been used for repairs, CE approval of the equipment will be withdrawn.
3. Use and operation
The Sentry is used in places where static electricity causes problems. The Sentry is capable
of neutralizing three-dimensional objects (e.g. moulded products) and larger areas.
The Sentry produces a wide, electrically charged air flow with positive and negative ions.
When this air flow is pointed to an electrostatically charged area, ions are exchanged until the
area is neutral. The air velocity of the Sentry can be adjusted to 3 positions. The equipment
has a built-in brush to clean the emitter points.
4. Technical specifications
Mains voltage:
Current:
Operating temperature:
Operating conditions:
Air volume:
Air velocity:
Range:
Noise level:
Ozone production:
Standards:
Optional:
air filter:
SENTRY_UM_9752066010_NL_D_GB_F_V2_0
®
Sentry
230 V AC; 50 Hz.
max. 0.5A
0 - 50°C
Industrial
3
120 - 205 m
/h
1.7 - 2.7 m/s measured at 60 cm distance
area of 90 cm x 180 cm
64 dB, measured at 60 cm distance at maximum speed
0.005 ppm, measured at 15 cm distance at the front
in accordance with European directives
open-cell polyurethane foam, 30 PPI
GB
15