Hendi 221099 Mode D'emploi page 6

Operation
• Connect the power plug to a suitable electrical
outlet.
• Switch on the power switch to the position "I".
Green indicator lights up.
• Align the centre of the fruit with the juicer head.
And put the handle down. Press the handle down
with some force to make juicer head rotate.
Overheat protection
There is a built-in motor thermal cut-out to protect the motor from overheating.
• When the motor is running very slowly or it stops,
this thermal cut-out activates.
• To reset it, switch OFF the appliance to the "0"
position and unplug it.
Cleaning and Maintenance
Important! Unplug the power cord from the electrical outlet before cleaning the appliance.
• Remove all accessories from the motor unit.
• Rinse all parts that contact with juice directly af-
ter use.
• Straight after use, hold the cone under warm
flowing water, clean it with a soft brush (not sup-
EN
plied) and then let it dry.
• Clean the bowl, block juice cover with warm wa-
ter with some mild soap solution.
• Never immerse the motor unit under water.
Clean and wipe the motor unit and housing with a
slightly damp cloth.
Troubleshooting
If the appliance does not function properly, please check the below table for the solution.
If you are unable to solve the problem, please contact the supplier / service provider.
Problem
Motor does not run after being switched
ON.
Motor is running with loud noises and
great vibrations.
Motor slows down & stops.
6
• Repeat above operation and change to another
fruit if no more juice coming out from the spout.
Note: 1. Empty the cone regularly to avoid overflow
• Leave the appliance for cooling down for about
30 minutes.
• Then, the appliance can be used again after
switch ON.
• Bowl pressing assembly can be detached by un-
screwing as below figure in counterclockwise di-
rection holding the handle.
• Store the appliance in a cool, dry place and out of
reach of the children.
• No any accessories/parts are dishwasher safe.
Possible cause
The appliance does not plug in properly
with the electrical power outlet
- The appliance is not well assembled.
- Too many ingredients that clogged in-
side the blade in the basket assembly
- Suction feet not have firm contact with
the surface
Built-in overheating device activates.
or jamming.
2. Warning: Kitchen utensils should not be
used under any circumstances to push the
fruit into the appliance. This will damage
to the appliance.
Possible solution
Check again the plug to see if it is con-
nected properly
- Unplug it and reassemble the appliance
correctly (See → Assembly).
- Unplug it. Clear some food & restart.
- Make sure the suction feet have contact
with the surface firmly.
- Switch OFF the appliance by pressing
the switch to "0" position and unplug the
appliance.
- Leaving the appliance to cool down for
about minutes and start again.