Preparations.before.use; Getting.accurate.readings; Automatic.shut-Down.function - Tanita InnerScan BC-587 Mode D'emploi

PREPARATIONS BEFORE USE
Handling Tips
This monitor is a precision instrument utilizing state-of-the-art technology.
To keep the unit in the best condition, follow these instructions carefully:
• Do not attempt to disassemble the measuring platform.
• Store the unit horizontally, and place it so that the buttons will not be pressed accidentally.
• Avoid excessive impact or vibration to the unit.
• Place the unit in an area free from direct sunlight, heating equipment, high humidity, or extreme temperature change.
• Never submerge in water. Use alcohol to clean the electrodes and glass cleaner (applied to a cloth first) to keep them shiny; avoid
soaps.
• Do not step on the platform when wet.
• Do not drop any objects onto the platform.
GETTING ACCURATE READINGS
Heels centered on Toes may overhang
electrodes measuring platform
Note: An accurate reading will not be
possible if the soles of your feet are
not clean, or if your knees are bent or
you are in a sitting position.
AUTOMATIC SHUT-DOWN FUNCTION
The automatic shut-down function shuts off the power automatically in the following cases:
• If you interrupt the measurement process. The power will shut down automatically within 10 to 20 seconds, depending upon the
type of operation.
• If an extreme weight is applied to the platform.
• During programming, if you do not touch any of the keys or buttons within 60 seconds.*
• After you have completed the measuring process.
*Note: If the power shuts off automatically, repeat the steps from "Setting and Storing Personal Data in Memory" (p.3).

Inserting the Batteries
Open the battery cover on the back of the measuring platform. Insert the supplied AA-
batteries as indicated.
Note: Be sure that the polarity of the batteries is set properly. If the batteries are incorrectly
positioned the fluid may leak and damage floors. If you do not intend to use this
unit for a long period of time, it is advisable to remove the batteries before storage.
Please note that the included batteries from factory may have decreased energy levels over
time.
Positioning the Monitor
Place the measuring platform on a hard, flat surface where there is minimal vibration to
ensure safe and accurate measurement.
Note: To avoid possible injury, do not step on the edge of the platform.
To ensure accuracy, readings should be taken without clothing and under consistent
conditions of hydration. If you do not undress, always remove your socks or
stockings, and be sure the soles of your feet are clean before stepping on the
measuring platform.
Be sure that your heels are correctly aligned with the electrodes on the measuring
platform. Don't worry if your feet appear too large for the unit - accurate readings
can still be obtained if your toes overhang the platform.
It is best to take readings at the same time of day. Try to wait about three hours after
rising, eating, or hard exercise before taking measurements.
While readings taken under other conditions may not have the same absolute
values, they are accurate for determining the percentage of change as long as the
readings are taken in a consistent manner. To monitor progress, compare weight
and body fat percentage taken under the same conditions over a period of time.