dirna Bergstrom Bycool Green Série Instructions De Montage page 15

SLIMFIT
6 CABIN EXTERIOR:
Position the Slimfit in the hatch on the EPDM
seal.
7 Position the mounts with (4) 8/125x55 screws,
(4) Ø8 wide-rimmed flat washers and (4) Ø8
grower washers, screwing on Ø8 hexagons.
8 Position the console in the interior air distribution
panel and align the unit to ensure the console is
in the ideal position.
Take care to check that recirculation is inside
the hatch gap, the base of the unit covers the
EPDM seal on all sides and the water run-offs
are on the outside of the EPDM seal once the
unit is aligned.
9
Secure the fastening screws until the mounts
come into contact with the M8 hexagons.
9
Air conditioning for vehicles
Hatch
7
8
9
15
EN
6