Publicité
Les langues disponibles
Les langues disponibles
Attention: You may invert functions at the model by repeating the programming at that function
and moving the respective gimbal stick to the opposite side (only possible with GigaTronic V2).
Alternatively you may reverse the function at the transmitter.
Take-Off preparation after channel assignment
•
(optional) Flight Phase Switch to Hover, Mode to Off
•
Move Pitch to minimum
•
Switch on transmitter
•
Connect flight battery
( Depending on the receiver used it may take several seconds until the receiver LED indicates stand-by
mode. Should the GigaTronic LED flash red, just disconnect the flight battery and reconnect it again.
•
System initialization.
•
System ready for operation. GigaTronic LED flashes green.
•
Check directional movement of Pitch and Swash Plate.
•
( Optional) Move Mode Switch to Heading Lock, LED will light up green.
•
System is ready for take off.
Installation of the Single Line Converter and the receiver into the ECO7 helicopter
ECO 7 Ranger: Smaller receivers may be placed with the SLC in the mechanics well of the fuselage (picture
1). In case you are using a larger receiver, place the components into a foam tube, which can be pushed into
the rear section of the fuselage (picture 2).
1
2a
2
2b
8
Single Line Converter
with receiver
Publicité
