Analog Bar Graph; General Specification - USAG 076 F Manuel D'utilisation

13 The batteries in the battery compartment are low and should be replaced immediately.
Warning:
as soon as this lowbattery indicator appears.
14 Battery internal resistance test indicator. It appears when battery internal resistance test is enabled.
15 Battery internal resistance test is in Fixed Time Test mode.
16 Battery internal resistance test is locked so that you can perform the test continuously as long as as you like.
Number of cylinders of the engine to be tested
17
18. Units on the LCD
mV, V
A, mA, A
m , , k , M
Hz, kHz, MHz
RPM
°C, °F
Unit of dwell angle °: Degree
°
Unit of duty cycle % : Percent
%

18. Analog Bar Graph

The length of its lit segments is proportional to the present reading on the LCD. The bar graph is like the needle on an analog
meter. It has an overload indicator ( ) on its right and a negative polarity indicator (
rapidly changing inputs. The number of lit segments indicates the measured value and is relative to the full-scale value of the

GENERAL SPECIFICATION

Maximum Voltage between any Terminal and Earth Ground: 600V DC or AC rms
Fuse Protection for "A°C°F" Terminal Inputs:
Display: 3 3r4-digit LCD, with a max. reading of 3999
Overrange Indication:
Negative Polarity Indication: "
Sampling Rate: about 2-3 times/sec
Operating Temperature: 0° C - 40° C, < 75% RH
Storage Temperature: -20° C - 60° C,< 85% RH
Operating Altitude: 0 to 2000 meters
Battery: 1.5V battery, AA or equivalent, 6 pieces
Low Battery Indication: "
Dimensions:
Weight: about 705g (including batteries)
mV
3
" displayed on the LCD automatically
" shown on the display
21
) on its left. Because the bar graph