General Operation - Laserworld FX Série Mode D'emploi

Manual: FX Series

6. General Operation

1. Power
Connect device power plug to the mains. Make sure that your device is provided with the
correct voltage. Wrong voltage could lead to irreparable damages. Please find the correct
voltage data in the synoptical table at the end of this manual. Make sure that the device
is not directed to people or inflammable objects during installation. To start the device
just switch it on.
2. Modes / Functions
The different operation modes can be selected via the four buttons next to the „Set-
tings" display.
„Mode" button allows navigation through menu. Press once to jump to next menu
point.
„Up" / „Down" allows for changing values.
„Exit" confirms a selection.
2.1. MENU DESCRIPTION
LED Display
R 1 Single Red, the number shows the current rotation speed
G 1 Single Green, the number shows the current rotation speed
B 1 Single Blue, the number shows the current rotation speed
Y 1 Single Yellow, the number shows the current rotation speed
C 1 Single Cyan, the number shows the current rotation speed
P 1 Single Purple, the number shows the current rotation speed
H 1 Single White, the number shows the current rotation speed
AUTF Auto mode with fast run
AUTS Auto mode with slow run
AUTH Auto mode with slow run for white color laser
A001 DMX mode, DXM address range from 1 to 511
SLAV Slave mode
page 8 / 26
Description
English
2.2. AUTO
Auto operation allows to random playback the internal sequences. They are played back
according to the internal system settings.
Select „AUTF" for fast run by navigating with the „Up" / „Down" buttons and confirm with
„Enter".
Select „AUTS" for slow run by navigating with the „Up" / „Down" buttons and confirm with
„Enter".
Select „AUTH" for slow run for white color by navigating with the „Up" / „Down" buttons and
confirm with „Enter".
2.3. DMX 512
The DMX mode requires a DMX controller or a Master laser (see 2.4. Master-Slave operation)
to be connected to the laser.
To switch to DMX mode, select „A001" by navigating with the „Up" / „Down" buttons. Use the
„Up" / „Down" buttons to set the desired DMX address and confirm with „Enter".
DMX Chart
The laser uses 7 DMX channels, so make sure that the next device uses an address that doesn't
overlap with this range.
Channel Value
1 Operation mode 0 - 49
50 - 99
100 - 149
150 - 199
200 - 255
2 Red Laser Dimmer 0 - 255
3 Green Laser Dimmer 0 - 255
Blue Laser Dimmer
4 0 - 255
5 Strobe 0 - 4
5 - 255
6 Rotation Speed 0 - 255
7 Rotation Direction 0 - 99
100 - 199
200 - 255
English
Manual: FX Series
Function
Laser off
AUTO Fast Mode, seven-color laser effect
AUTO Slow Mode, seven-color laser effect
AUTO White Mode, white color laser effect
DMX Manual Mode, CH2~CH7 valid
Dimmer laser output power from 0% to 100%
Dimmer laser output power from 0% to 100%
Dimmer laser output power from 0% to 100%
No strobe
Strobe from fast to slow
Speed from fast to slow, 255 is stop
Clockwise rotation
No rotarion
Counter clockwise rotation
page 9 / 26