Alpina SF-5003 Mode D'emploi page 3

Dear Customer,
Thank you for choosing this ALPINA home appliance. Your Alpina appliance comes with a 2 year warranty and will
provide years of service if looked after properly. The ALPINA name brings you Quality, Reliability and Dependability. We
hope you will continue to make ALPINA your first choice in home appliances.
When using electrical appliances, basic safety precautions should be followed:
1. Read all instructions carefully.
2. Make sure the power supply corresponds to one on the rating label.
3. To avoid electrical shock, do not immerse electrical parts in water or other liquid.
4. Do not allow children to operate or play with the appliance.
5. Unplug from outlet when not in use, or before putting on/taking off parts.
6. Do not use with damaged electrical cord or plug.
7. If damaged or malfunction occurs, refer to an authorized service center only.
8. Do not place on or near hot surfaces.
9. Never pull the appliance by the power cord.
10. Do not use the appliance for other than intended household use.
Warning: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities or lack of experience and knowledge, unless they have been given supervision or instruction by a person
who is responsible for their safety concerning the use of the appliance. Children should be supervised to ensure that
they do not play with the appliance.
INSTRUCTIONS FOR USE
How to Assemble:
1. Remove all parts from the carton:

Motor Assembly (grill nut, blade knob & fan base)

Grill set (front & rear) , Fan blade

Pole Assembly and Upright post

Logo plate & screws
2. Fan head Assembly

Remove the grill nut and blade knob from the motor assembly.
Note: Blade knob is reverse threaded and should be turned clockwise to remove from the motor shaft.

Place the motor assembly on a flat surface with the shaft facing up .Place the rear grill over the motor shaft and
to motor assembly, the rear grill handle should be positioned toward the top of fan and two holes in rear grill
should be aligned with two small plastic pins on the motor assembly. Turn and tighten the grill nut on to the
motor housing securing the rear grill to the motor assembly.

Mount the fan blade on motor shaft by aligning the D shaped hole in the fan blade with the D shaped motor
shaft. Insert the fan blade as far as possible on the motor shaft and secure with blade knob by turning it counter
clockwise. Do not over tighten.

Mount the front grill cover on the rear grill cover by fully opening the clips around outer edge of the front
grill .Align the top center of front grill with the rear grill. Hold the front grill against the rear grill and push open
clips on the front grill inward until front grill is secure against the rear grill.
IMPORTANT SAFEGUARDS
ENGLISH