Omnitronic CDP-386 Mode D'emploi page 20

4.2 Main unit
Frontpanel:
1. MAIN POWER SWITCH
Press this button to start operation.
2. DISC TRAYS
To enter the discs.
3. OPEN/CLOSE BUTTONS
Press this button to open the respective CD tray. Press the button a second time and the tray will close
again.
CAUTION: Do not close the tray by pushing it as this could harm the construction.
Rear panel:
4. POWER CONNECTION
CAUTION: In order to avoid severe damage, make sure that the device is unplugged and that the voltage
selector (7) is set to the right position before you connection the player.
5. AUDIO OUTPUT
Each player and each channel has an output jack. Connect the output to the respective input of your mixer
only.
6. REMOTE CONTROL
Connect the controller via these plugs. Make sure that you connect the player Unit 1 to the controller Unit 1
and the player Unit 2 to the controller Unit2.
7. VOLTAGE SELECTOR
Make sure that the indication corresponds to the available voltage.
8. DIGITAL OUT-SOCKET
The music-signal of this socket is digital. Connect the output to the respective input of a digital amplifier for
example.
20/48 1060225E_V_1_0.DOC