Bosch ART 35 Notice Originale page 11

OBJ_BUCH-1800-004.book Page 11 Tuesday, August 29, 2017 8:22 AM
Keep the supply cables away from mov-
ing hazardous parts and avoid damage
to the cables; this can lead to contact
with live parts.
The connections (plugs and sockets)
should be kept dry and off the ground.
The supply cables must be inspected
for signs of damage at regular intervals
and may only be used if in perfect con-
dition.
If the supply cable on the product is
damaged, it must only be replaced by a
Bosch Service Centre.
Only use approved extension cables.
Extension cords, cables, leads, reels
should only be used if they comply with
EN 61242/IEC 61242 or
IEC 60884-2-7.
If you want to use an extension cable
when operating your product, only the
following cable dimensions should be
used:
– Nominal Conductor Area of
2
1.25 mm or 1.5 mm
– Maximum length of 30 m for a Cord
Extension Set or maximum length of
60 m for a Cable Reel with Residual
Current Device (RCD
Note: If an extension cable is used it
must be earthed and connected
through the plug to the earth cable of
your supply network in accordance
with prescribed safety regulations.
If in doubt contact a qualified electri-
cian or the nearest Bosch Service Cen-
tre.
Bosch Power Tools
socket must be of watertight con-
struction and intended for outdoor
use.
For products not sold in GB:
WARNING: For your safety, it is re-
quired that the plug attached to the
product is connected with the exten-
sion cord. The coupling of the exten-
sion cord must be protected against
splash water, be made of rubber or
coated with rubber. The extension cord
must be used with a cable strain relief.
 Products sold in GB only: Your prod-
uct is fitted with a BS 1363/A ap-
proved electric plug with internal fuse
(ASTA approved to BS 1362).
If the plug is not suitable for your
socket outlets, it should be cut off
and an appropriate plug fitted in its
place by an authorised customer ser-
vice agent. The replacement plug
2
should have the same fuse rating as
the original plug.
The severed plug must be disposed of
to avoid a possible shock hazard and
should never be inserted into a mains
socket elsewhere.
Products sold in AUS and NZ only:
Use a residual current device (RCD)
with a rated residual current of 30 mA
or less.
Symbols
The following symbols are important for reading and under-
standing the operating instructions. Please take note of the
symbols and their meaning. The correct interpretation of the
symbols will help you to use the garden product in a better
and safer manner.
WARNING! Inadequate exten-
sion cables can be dangerous.
Extension cable, plug and
F 016 L81 763 | (29.8.17)
English | 11