The Introduction Of The Panel - Detectalia V100 Manuel D'utilisation

3. The introduction of the panel

BATCH
START
+1/+10
MENU
REP
ENTER PRINT
Key
In the manual counting mode, press this key to start counting.
START
Press this key to enter into the MENU Interface.
Long press this key and turn on the machine in the
MENU
meantime, can enter into the calibration mode.
In the MENU interface, press this key can save the change and back
to the previous interface.
ENTER
Press this key to confirm or enter into the sub-menu.
Press this key can turn on/off the batch function, and the user can se-
BATCH
lect the batch number among "100, 50, 20, 10, 5, off" by short pressing.
In the normal counting interface, press this key to turn on the BATCH
function; short press this key to "+1"; long press this key to "+10".
In the MENU interface, press this key to adjust up sensitivity level or
+1/+10
other setting.
In the time setting, press this key to increase.
8
MODE
START
CUR
ADD MENU
CLEAR ENTER
Function
Key
Press this key to check the current counting report.
In the MENU interface, press this key to decrease sensitivity level or
REP
other setting.
In the time setting, press this key to decrease.
Press this key to print the current counting report.
PRINT
In the MENU interface, press this key to return previous interface.
1.Press this key to switch the counting mode: UV/MG, MIX, SGL, CNT.
(UV/MG: count the banknote with UV/MG detection.
MIX: count different denomination of one kind of currency together,
showing the counting amount.
MODE
SGL: count one denomination of one kind of currency together,
showing the counting amount.
CNT: only with counting function, without any detection. )
Press this key to choose the currency.
In the MENU interface, press this key to switch settings forward.
CUR
In the time setting, press this key to move right.
Press this key to turn on/off the ADD (accumulation) function.
In the MENU interface, press this key to switch settings backwards.
ADD
In the time setting, press this key to decrease.
In the time setting, press this key to move left.
Clear the counting result.
In the MENU interface, press this key to return previous interface.
CLEAR
In the time setting, press this key to change the time.
V100
Function