Options - Hotpoint LSFA+ 825 Mode D'emploi

Options

Notes:
Optimum performance levels when using the "Daily and "Speed"
cycles can be achieved by respecting the specified number of
place settings.
To reduce consumption, only run the dishwasher when
it is full.
Note for Test Laboratories: for information on comparative EN
testing conditions, please send an email to the following address:
assistenza_en_lvs@indesitcompany.com
Wash options
The OPTIONS may only be set, modified or reset after
the wash cycle has been selected and before the Start/
Pause button has been pressed.
Only the options which are compatible with the type of wash
cycle set may be selected. If an option is not compatible
with the selected was cycle (see Table of wash cycles) , the
corresponding LED flashes rapidly 3 times.
If an option is selected which is incompatible with another
option or wash cycle selected previously, the incompatible
option light will flash 3 times and switches off, while the most
recently selected setting remains lit.
To deselect an option which has been set by mistake, press
the corresponding button again.
Delayed start
The start of the wash cycle may be delayed for a
period of time between 1 and 24 hours.
1. After selecting the desired wash cycle and any
other options, press the DELAYED START button: the
corresponding indicator light will illuminate. Use the same
button to select the time at which you wish the wash cycle
to begin (after a period of 1 to 24 hours).
2. Confirm your selection using the Start/Pause button; the
countdown will begin. The selected delay period indicator
light is displayed and the Start/Pause button stops flashing
(the light becomes fixed instead).
3. When the set time has elapsed, a long beep sounds, the
DELAYED START indicator light switches off and the wash
cycle begins.
To deselect the DLEAYED START option, press the DELAYED
START button repeatedly until the text OFF appears.
The Delayed Start function cannot be set once the
wash has been started.
Half load
If there are not many dishes to be washed, a half load
cycle may be used in order to save water, electricity
and detergent. Select the wash cycle and press the HALF
LOAD button: the indicator light will illuminate.
Remember to halve the amount of detergent.
It is better to use powder detergent in this case.
Multi-functional tablets (Tabs)
This option optimises washing and drying results.
When using multi-functional tablets, press the MULTI-
FUNCTIONAL TABLETS button. The corresponding indicator
light will illuminate. The "Multi-functional tablets" option results
in the lengthening of the wash cycle.
The MULTI-FUNCTIONAL TABLETS option remains
set for subsequent wash cycles if it is not deselected.
The use of tablets is only recommended for models
which offer the MULTI-FUNCTIONAL TABLETS option.
This option is not recommended for use with wash
cycles which do not specify the use of multi-functional
tablets.
*
Only available in selected models.
EN
11