Bitron Video PROXIMAN AV0151/005 Manuel D'instructions page 4

ENGLISH
CABLING
1
The wires used to link the readers and other peripherals must be installed in accordance with European
standards NE61000-4-4, which describes a protected area.
Information about the CE norms:
In accordance with the European directive R&TTE 99/5CE and the harmonised norms ETS 300 683 ( 1997 ) and
ETS 300 330, the controller Proximan complies with the EMC norms regarding radio transmitting devices.
Proximan also complies to the European directive regarding the low voltage directive EN 60 950 (2000).
GENERAL FEATURES
2
The controller Proximan
1) Wires way
2) Programmation buttons
3) Display 2 X 16 characters
4) RS 485 Bus for optional devices
5) Connector for optional intercom
6) For backup memory
7) Holes for screws fi xation
8) DIN rail fi xation
9) Smart card reader
10) Door 4 (Reader + PushButton + Exit relay
dry contact)
11) Door 3
12) Door 2
13) Door 1
14) Earth connection
15) Box for connection protection
16) Service smart card
17) Backup memory
18) Power supply (continu or alternative)
19) Programmation reader
IT IS HIGHLY RECOMMENDED TO USE A DIFFERENT POWER SUPPLY FOR THE ELECTRICAL LOCKS (NORMAL OR
MAGNETIC LOCK)
6
179 mm
1
19 2 3 4 5 6
Intercom
Programming
Display
reader
Memory backup
Command buttons
Smart card reader
T Door N° 1 Door N° 2 Door N° 3 Door N° 4
∼/+ ∼/−
18 14 13 12 11 10
15
17
8
15
DS90355-015
BOX: ............................................................................................................... Non fl ammable ABS VO
OPERATING TEMPERATURE: ................................................................................ From –20 °C to +70 °C
FIXATION: ............................................................... On DIN rail / on a wall with 4 screws 4mm diameter
Power supply : .................................................................................................... 12 ÷ 24 V = or ~ (1 A)
Controller PROXIMAN cabling
Power supply
~/+ Plus continue/12 V ~
~/- Negative Cont. /12 V ~
T Earth Connection
Doors N°1
Reader door 1
L1+ Plus N°1 reader
L1- Negative N°1 reader
Door 1 exit push button
BP1+ + door 1 push button
BP1- - door 1 push button
Relay door 1
COM1 Door 1 common
NF1 Door 1 normally closed contact
NO1 Door 1 normally open contact
Following doors
Reader door X
LX+ Plus N°1 reader
7
LX- Negative N°1 reader
Door x exit push button
BPX- - exit button door X
BPX+ + exit button X door
Relay door X
COMX Door 1 common
NFX Door 1 normally closed contact
NOX Door 1 normally open contact
2 wires readers cabling
9
D+ Power Supply
D- Ground
Reader with interface cabling
16
L+ Power Supply
L- Ground
RF Receiver
D+ Power Supply
D- Ground
DS90355-015 7