BOMANN WAA 936 E Notice D'emploi page 27

V- SPEED PUSH-BUTTON "rpm" ( It does no ligh up)
When this button is pressed the spin speed can be selected (Max./0 rpm). The speed
appears in the display and changes every time the button is pressed. It can only be
selected below the preset speed for each selected programme.
T- DELAY PUSH-BUTTON (The display schows the time in hours when switched on)
This button lets us delay the starting of the machine from 1 to 16 hours. For this
function proceed in the following way:
1st- Select the desired progrmme following the usual steps.
2nd- Press several times the button until the displays shows the hours left to the
starting. (Each touch increases one hour).
3rd- Press the Start button (St).
The electronic timer then starts ito count the selected time down to cero. At that
moment the washing programme starts, and it is automatically carried out until the end
of the washing cycle.
St- PROGRAMME START PUSH-BUTTON (START)
When this button is pressed the machine start and carries out autmatically the selected
prog ramme. Once star ted it is not possible to change the prog ramme settings.
When the programme is selected or stated the button lights up and the two dots between
the f irst and the second digit in the display flash.
To change a programme that has alresdy been selected it is necessary to turn the
Programme Selector (P) to the STOP position. The machine automatically resets.
In this position (STOP) the display is blank and the trhee horizontal lines flash.
VS- GENERAL DISPLAY READINGS
The display is divided in two parts by a horizontal line. Above the line different signs (washing,
rinsing, spin) show the current programme operation and different numbers show the programme
time or the delay time.
The spin cycle speed is shown below the line.
When the On/Off button is pressed the display shows:
1st- When the Programme Selector (P) is in the STOP position: The display lights up and the
trhee horizontal lines that indicate the RESET position flash.
2nd- When the (P) selector I set in a programme: The display lights up, the two dots flash and the
programme function sign (washing, rinsing, spin), the length of the programme in hours:minutes
and the maximum spin cycle speed are shown. When the START button is pressed in linghts up
and the programme stsrts. As the programme is carried out the display shows the sign of the
current operation and the time left. When the programme is finished the display shows End.
3rd- When the (P) selector is set on a programme with delay: Same as in te 2- point-instead of
showing the programme time, the display shows the tme left to the starting.
When the delay time is over, the display shows the programme time and machine starts
automatically and car ries out the programme until the displays shows End.
27
14I