BOMANN WAA 936 E Notice D'emploi page 26

X- ON/OFF PUSH-BUTTON
When this button is in the ON position (pressed), it turns on the power so sthat the
electronic circuit can receive the progrmme and starting orders.
P- PROGRAMME AND TEMPERATURE SELECTOR
This selector sets the programme and the temperature according to the kind of clothes
and dirt that is to be washed (See programme start). To set the programme, turn this
selector clockwise until the notch points to the temperature corresponding to the
indicated programme or function. There is a maximum spin speed foe each programme,
automatically selected when the programme is set.
The display in the front frame shows the programme length in hours and minutes
(h.min.).
W- FULL TUB STOP PUSH-BUTTON (Lights up when switched on)
When this button is pressed, the washing cycle stops with the tub full of water in the final
rinse of the Synthetic (6, 7, 8), Delicate (9, 10) and Wool (11, 12, 13) programmes. This
operation is useful to prevent creases on certain clothes that must be hung out wet.
When the programme reaches the Full Tub Stop position the button light flashes. To empty
the tub and finish the washing cycle, press this button again. It will stop flashing and will
carry out the rest of the washing cycle.
En- PROGRAMME-ENEGETIC PUSH-BUTTON (Lights up when switched on)
When this button is pressed, the washing time in the Cotton (1, 2, 3, 4, 5) and Synthetic
(6, 7, 8) programmes increases in about 22 minutes, carrying out a more energetic
programme that allows for better washing results in the aforementioned programmes
when the user considers this is needed.
Pr- PRE - WASH PUSH-BUTTON (Lights up when switched on)
When this button is pressed, the washing machine carries out a 40º/30º C pre- wash in
the Cotton (1, 2, 3, 4, 5) and Synthetic (6, 7, 8) programmes in addition to the selected
cycle (See programme chart). The time given on the programme chart increases in
about 10 minutes when this function selected.
A- ANTI-CREASE PUSH-BUTTON (Lights up when switched on)
When this button is pressed the selected washing programme is carried out until the end of the
cycle, including the spin cycle, At that point the tub rolls slowly for about 30 minutes ar a rate of
5" rolling and 120" stopped, creating a sponge effect suitable for certain delicate clothes.
This button only works in the following programmes: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 16, 17 and 19.
It limits the spin cycle speed to a maximum of 800 rpm.
It increases the time given on the programme chart in 28 minutes.
Y- EXTRA RINSE PUSH-BUTTON (Lights up when switched on)
When this button is not pressed the machine carries out automatically programmes 1, 2, 3, 4, 5,
6, 7, 8, 16, 17 and 18 saving a considerable amount of water. Only recommended when the load
is half load or less.
With bigger loads it is recommended to press this button to ensure a better efficiency in rinsing
out the detergen remains. In this case time given on the programme chaet increases in about 10
minutes.
26 13I