tuc tuc WHEELED BOARD WITH SEAT Mode D'emploi page 10

WARNINGS!
• TO PREVENT THE RISK OF ASPHYXIATION, REMOVE ALL PLASTIC WRAPPING BEFORE
USING THIS PRODUCT. THE WRAPPING MUST BE DISCARDED OR KEPT OUT OF REACH OF
BABIES AND CHILDREN.
• Never leave the child unattended.
• This product is designed to be used by children who are older than 15 months and whose
weight does not exceed 20 kg.
• Ensure that all the locking devices are engaged before use.
• To avoid injury ensure that the child is kept away when unfolding and folding this product.
• Do not let the child play with this product.
• This product is not suitable for running or skating.
• Any load attached to the handle and/or on the back of the backrest and/or on the side
of the vehicle will affect the stability of the vehicle.
• The board part must not be used by more than one child.
• Do not use accessories that have not been approved by the manufacturer.
• Only use replacement parts that have been supplied or recommended by the
manufacturer/distributor.
1. Attaching and removing the wheels
1. Attaching the wheels (see the first two images in Figure 1): Position the wheel at the opening
inside the base towards the rear, and press gently until you hear a "click". Then, pull gently on
the wheel until the pivot emerges. This indicates that the wheel is in the correct position.
2. Removing the wheels (see the last two images in Figure 1): Press and hold down the release
button, then pull the wheel out in the direction of the arrow.
2. Attaching the board part
1. Unscrew the knob at the side of the linkages, moving it in an anticlockwise direction. Then
push it forwards. (See Figure 2.)
2. Insert the end of the strap into the board part, placing it flush against the rear bar in order
to make it as tight as possible. Then turn the knob at the side in a clockwise direction, in order
to fasten the strap to the most secure point of the buggy's chassis.
3. Position the fasteners on both sides of the buggy's chassis. Make sure they are securely
attached and do not slide down the tubes of the chassis. (See Figures 2.2 to 2.5.)
4. To separate the connectors at the ends of each of the arms of the board part again, push
back the knob on the adjustable fixed section, then remove the ends of each of the arms of the
board part.
5. Press and hold down the fasteners, pull back, undo the buckle and release the adjustable
fixed section from the rear bar.
10