DNT DigiMicro Scale Mode D'emploi page 19

Additional Information
For correct function of the software 2 things are to be considered:
1. You must have administrator privileges on your computer, otherwise you get error
messages.
2. You must have installed PC DirectX9c on your computer. To determine whether
DirectX9c is installed, enter the Start> Run the command „dxdiag".
The DigiMicro has two fi xed focus settings. Turn the knurled screw accordingly. Near
the right keystroke you get the low magnifi cation, in the vicinity of the left keystroke
you get high magnifi cation.
Turn the thumbscrew to the right keystroke. Set a soft-
ware preview to the size of 1280x960
Set the DigiMicro with the illuminated front to the cen-
tre of the drawing (left).
Wait 2 seconds until the white balance is adjusted.
Turn the thumbscrew slowly to the left.
First you see the outer circle on full screen. This is the
low magnifi cation. It has a diameter of 6mm.
Now, if you continue turning the thumb wheel to the
left, you see the inner circle full screen. This is the
high magnifi cation. It has a diameter of 1.5 mm.
- 19 -