Fitting The Air Gun; Connecting Compressed Air Hose; Putting Into Use - Simco-Ion COBRA Notice D'utilisation

5.2.2. Fitting the air gun

1. Remove the lid from the power unit.
2. Remove one of the central blind glands from the rear of the box.
3. Fit the gland with the air gun cable into this opening.
4. Connect the wiring of the air gun, using the relevant screws.
5. Tighten the gland pull relief.
6. Place the cover onto the box and tighten it.
connection to Cobra

Important:
 Make sure that the HV cable is not looped inside the housing.

5.2.3. Connecting compressed air hose


Important:
 The compressed air to be used must be clean, dry and free of oil.
It is recommended to use an air filter.
 Use a pressure regulator to adjust the blow-off power.
1. Remove the air connecting nipple from the gun.
2. Wrap sealing tape around the nipple.
3. Turn the nipple into the gun.
4. Connect the air hose to the connecting nipple.
5. Connect the air hose to your compressed air installation.

6. Putting into use

 Make sure the gun is supplied with compressed air.
 Switch on the power unit.
 Point the air gun to the object to be cleaned.
 Pull the trigger of the air gun.
Cobra_UM_9752050610_NL_D_GB_F_V2_0 18