Publicité
Les langues disponibles
Les langues disponibles
FAULT
See causes for no. 5
Bottom of saucepans have not
been washed well
Edge of saucepans have not
been washed well
Spray arms are partially blocked
7 - Load of dishes is only
partially washed
The dishes have not been
properly loaded
The end of the outlet hose is in
the water
The incorrect amount of
detergent has been measured
out; the detergent is old and hard
The wash programme is not
thorough enough
The lower basket dishes have
not been washed
8 - Detergent not dispensed
Cutlery, dishes, pans, etc... stop
or partially dispensed
the detergent dispenser opening
9 - Presence of white spots
Water is too hard
on dishes
10 - Noise during wash
The dishes knock against one
another
The revolving arms knock against
the dishes
11 - The dishes are not
Inadequate air flow
completely dry
Rinse aid missing
N.B.: Should any of the situations
occur and should the machine give a bad wash performance,
deposits from the dishes by hand since the final drying cycle hardens the deposits which a second wash
in the machine would not be able to remove.
If the malfunction continues contact a Service Centre quoting the serial number of the dishwasher.
This is found on the plaque on the inside of the dishwasher door at the top or on the guarantee.
This information will make it possible to take more effective action more quickly.
The manufacturers decline any responsibility for any printing mistakes in this instruction booklet.
They also reserve the right to modify their own appliances as necessary without altering the
essential characteristics.
CAUSE
REMEDY
Check
Burnt on food remains must
be soaked before putting pans
in dishwasher
Reposition saucepans
Remove spray arms by
unscrewing ring nuts clockwise
and wash under running water
Do not place the dishes too
closely together
The end of the outlet hose
must not come into contact
with the outflow water
Increase the measure
according to how dirty the
dishes are and change detergent
Choose a more vigorous
programme
Depress half load button
Position dishes not to obstruct
the dispenser
Check salt and rinse aid level
and regulate amount.
Should the fault persist,
Contact Service Centre
Re-check loading of dishes in
the basket
Again re-check loading
Leave the dishwasher door ajar
at the end of the wash program
to allow the dishes to dry naturally
Fill the rinse aid dispenser
it is necessary to remove the
110
Le constructeur décline toute responsabilité pour les éventuelles erreurs d'imprimerie
contenues dans le présent mode d'emploi. Il se réserve en outre le droit d'apporter
toutes modifications qui se révèleraient utiles à ses propes produits sans pour autant
en compromettre les caractéristiques essentielles.
Wij stellen ons niet aansprakelijk voor eventuele drukfouten. Kleine veranderingen en
technische ontwikkelingen zijn voorbehouden.
O modelo e caracteristicas indicados nesta folha podem ser alterados sem qualquer
aviso.
The manufacturer declines all responsibility in the event of any printing mistakes in this
booklet. The manufacturer also reserves the right to make appropriate modifications to
its products without changing the essential characteristics.
Publicité
