SOLAC HU1050 Mode D'emploi page 11

Libro HU1050.book Page 11 Monday, September 10, 2007 10:45 AM
• Do not touch the ultrasound transmitter with your hands or with tools.
• Do not use the humidifier when barefoot. Do not touch the appliance with
wet hands when in operation.
• When unplugging the appliance, do not pull on the power cord or the
appliance.
• Never leave the appliance outdoors exposed to the elements.
• The appliance and its power cable must not be placed under water in any
case.
• Do not fill it with hot water.
b
WARNING!!: When you want to dispose of the appliance, NEVER
throw it in the bin. Take it to your nearest RECYCLING POINT or
waste collection centre for treatment. You will thus be helping to take
care of the environment.
2 MAIN COMPONENTS
1 Water tank
2 Mist outlet
3 Ioniser function on/off switch
4 Pilot light
5 Mist on/off switch
6 Ionised air outlet
7 Pilot light showing that the ioniser function is active
8 Water level float
9 Transducer
10 Internal water tank
11 Brush
3 OPERATION AND USE
1 Separate the water tank (1) from the base, turn it over and remove the
cap from the bottom, turning it anticlockwise. Fig.1. Fill with cold water;
do not fill completely.
2 Replace the plug, aligning the notches on the tank with the grooves on
the cap, and turn it clockwise. Make sure it is well closed.
3 Turn the tank over and place it on its base making sure it fits perfectly.
4 When placing the water tank (1) back on the base, a part of the water it
contains enters the space between the tank and the body (10); this is
part of the normal operation of the appliance and does not entail any risk.
MAIN COMPONENTS
en
11