WLD-TEC Sterimax Mode D'emploi page 20

• If the quartz glass heating element (3a) exhibits any cracks, chips or
similar, turn off the device and unplug the mains plug (12) from power
socket. Do not use the device! Replace the heating element before
using the device again.
• If the ceramic annealing tube (3b) exhibits any cracks, chips or similar,
turn off the device and unplug the mains plug (12) from power supply (5).
Do not use the device! Replace the ceramic annealing tube (see paragraph
6). Check also if the quartz glass heating element (3a) is damaged.
Warning note in order to avoid the risk of fire and/or injuries.
• During the operation of the device, its components may get extremely
!
hot. Therefore, only touch the controls or the handle (4) for the adjustment
Surface
may be hot
of the device's angular settings.
• Never place your hands or any other body part above the opening of the
!
annealing tube (3)!
Surface
may be hot
• Combustible materials may ignite within the immediate area of or inside
the annealing tube (3)! Never place the device close to combustible objects
and / or materials. Never insert combustible materials or liquids into the
annealing tube (3).
• Never insert instruments or objects where flammable liquids or material
adhere to these instruments or objects into the annealing tube (3).
• Never cover up the annealing system as long as it is in use or its casing
is still hot.
• Operate the unit only on a stable, non-slip and level surface.
• During the heating-up of the annealing tube the display of the residual
heat (2) will be delayed. It is possible that the tube's casing is already
hot during the heating phase or before the residual heat display is
turned on.
20