Operation Procedure - ACV HP300 Manuel De Mise En Service, D'opération Et D'entretien

13 CLOCK indicator: It displays present time, it blanks during screen protection.
14 E_HEATER MODE indicator: When the user sets the E-heating Mode, it lights up.
15 HYBRID MODE indicator: When the user sets the Hybrid Mode, it lights up.
16 ECONOMY MODE indicator: When the user sets the Economy Mode, it lights up.
4.3. Operation
.
ON/OFF key, used to turn the
appliance on or off
CLOCK key, used to
set time
4.4.

Operation procedure

 Preparation before running the appliance
When you run the appliance for the first time, all the indicators on the User Interface will light up for 3
seconds, and the buzzer will "didi" ring twice at the same time, and then display is lit up. After no operation for
1 minute, all indicators will go out automatically, except Water fill indicator which is flashing and the temp.
indicator which is lighting.
When the tank is full, please press the ON\OFF key, then the Water fill indicator will stop flashing and you
can continue to function other settings. When all settings are finished, please press the ON\OFF key again and
the Water fill indicator will go out. And then run the appliance.
When the appliance is running, if there is no operation or malfunction for 20s, the backlight of the display
will go out automatically except the operation model, the outlet temp, the lock indicator. If there is no operation
for 1 minute, the appliance will lock automatically, but the lock indicator would be right all time.
 Lock and Unlock
In order to prevent wrong operation, a special lock function has been designed. If there is no operation for 1
minute, the appliance will be locked automatically, and lock indicator will be displayed. When the appliance is
locked, no keys can be operated.
Unlock:
 Clock set
The clock is for a 24-hour system and the initial time is 00:00. To make a better use of this appliance, it is
recommended to set the time for accurate local time. Every time powered off, the clock will be reset to the
initial time 00:00.
CANCEL key, used
to cancel time and
clock
TIME ON key, used to
set the ON timer
At the locking status of the display, long press the "CANCEL"
key to remove it. At the screen protection of the display, press
any key to activate the display, and then long press the
"CANCEL" key to remove it. After removal of the locking
mode, the Lock indicator will blank out and all keys could be
used normally.
EN
MODE key, used to set
different modes
TIME OFF key, used
to set the OFF timer
UP key, used to add
time or temperature
DOWN key, used to
reduce time or
temperature
16