Publicité
Les langues disponibles
Les langues disponibles
3 Operation
Charging station ATS-16PS:
Connect the power supply unit to the
jack DC IN situated on the side of the
charging station, then connect it to a
mains socket. Thus, the charging sta-
tion is switched on.
Charging case ATS-36C:
1) To open the case, press the grey but-
tons to unlock the two snap locks and
pull the locks towards you.
2) Connect the power supply unit fastened
in the case with Velcro to the jack DC IN
above it; then connect it to a mains
socket via the supplied mains cable.
The power LED on the power supply
unit will light up.
3) To switch on the charging case, set the
switch next to the jack DC IN to ON
(switch will light up).
After switching on, the LED OK and the LED
ON at each charging compartment will shortly
light up in succession. The charger will perform
a short self-test. At its end, the LEDs ON of the
charging compartments will shortly light up
again: The charger is now ready for operation.
4 Charging the Batteries
1) Insert the units (transmitters or receivers)
with their batteries into the charging com-
partments.
2) During the charging process, the orange
LED ON for the corresponding charging
compartment will light up. (If the LED
flashes, the batteries are not correctly in-
serted into the transmitter/receiver or non-
rechargeable batteries are used instead of
rechargeable batteries – in this case,
remove the unit from the compartment
immediately.)
3) When the batteries of a unit are fully
charged, the green LED OK of the charg-
ing compartment will light up.
All rights reserved by MONACOR
manual may be reproduced in any form or by any means for any commercial use.
4) To switch off
the charging station ATS-16PS, discon-
the charging case ATS-36C, set the switch
Note: When the charger is disconnected
from the power supply, allow the unit to reset
for 5 s before operating it again.
5 Specifications
Charging procedure: pulse charging with ∆V and
Charging current: . . 450 – 500 mA (ATS-16PS)
Charging time*: . . . . approx. 3 – 4 hours (ATS-16PS)
Ambient temperature: 0 – 40 °C
Power supply
ATS-16PS: . . . . . 12 V /500 mA via supplied
ATS-36C: . . . . . . 12 V /7 A via supplied switch
Dimensions, weight
ATS-16PS: . . . . . 105 x 72 x 84 mm, 168 g
ATS-36C: . . . . . . 86 x 23 x 35 cm, 9.6 kg
* for NiMH rechargeable batteries 1300 mAh
Subject to technical modification.
®
INTERNATIONAL GmbH & Co. KG. No part of this instruction
nect the power supply unit from the
mains socket. The LEDs ON will
shortly light up.
to OFF. The switch illumination will be
extinguished and the LEDs ON will
shortly light up. If the case is not used
for charging, disconnect the power
supply unit from the mains to prevent
unnecessary power consumption.
To close the case, fold down the
cover first; then push the snap locks
back into their locking position. Lock
the case with the one of the keys sup-
plied, if required.
timer control
300 – 330 mA (ATS-36C)
approx. 5 – 6 hours (ATS-36C)
power supply unit connected
to 230 V~/50 Hz
mode power supply unit con-
nected to 100 – 240 V~ /50 Hz
or 60 Hz
GB
7
Publicité
