EINHELL PROFI Silver Line PS-SB 650E Mode D'emploi page 14

Anleitung PS-SB 650 E_SPK1
GB
Switch the Drill/Hammer drill selector switch (2)
to the drill symbol position and start the hole.
Switch the Drill/Hammer drill selector switch (2)
to the hammer symbol position as soon as the
drill bit has passed through the tiles.
6. Cooling the motor
If the motor has overheated, allow it to run for 2
to 3 minutes at maximum speed without drilling
through any material.
7. CLEANING, MAINTENANCE AND
ORDERING REPLACEMENT PARTS
Pull the power plug before doing any cleaning and
maintenance work on the machine!
7.1 Cleaning
Clean the tool at regular intervals (remove all
dust, chips, splinters, etc.) We recommend that
you clean the tool immediately after you use it.
Clean the tool with a damp cloth and some soft
soap. Do not use cleaning agents or solvents;
these may be aggressive to the tool's plastic
parts. Ensure that no water can get into the interi-
or of the tool.
7.2 Maintenance
There are no parts inside the tool which require
maintenance.
7.3 Replacing the carbon brushes
Important! The carbon brushes should not be
replaced by anyone but a qualified electrician.
7.4 Ordering replacement parts
Please provide the following information on all orders
for spare parts:
Model/type of tool
Article number of the tool
ID number of the tool
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
14
18.08.2005 13:04 Uhr Seite 14