Philips PicoPix PPX5110 Manuel Utilisateur page 21

The CE marking certifies, that the product meets
the main requirements of the European Parlia-
ment and Council directives 2014/35/EU,
EN55032:2012+AC:2013(Class B), CISPR 32:2012,
EN61000-3, IEC61000-4, EN55024, EN55024/
A1, Draft EN 301 489-1, Draft EN 301 489-17, EN
300 328, EN 62311:2008,
EN60950/A2, EN60950/A11, EN 60950/A12 on
information technology equipment, regarding
safety and health of users and regarding elec-
tromagnetic interference.
The declaration of compliance can be consulted
on the site www.picopix.philips.com.
Preservation of the environment as part of a
sustainable development plan is an essential
concern of X-GEM SAS. The desire of X-GEM
SAS is to operate systems respecting the envi-
ronment and consequently it has decided to
integrate environmental performances in the life
cycle of these products, from manufacturing to
commissioning use and elimination.
Federal Communications Commission (FCC)
Statement: You are cautioned that changes or
modifications not expressly approved by the
party responsible for compliance could void the
user's authority to operate the device.
This device has been tested and found to com-
ply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This device generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interfer-
ence will not occur in a particular installation. If
this device does cause harmful interference to
radio or television reception, which can be
determined by turning the device off and on, the
user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
• Adjust or relocate the receiving antenna.
• Increase the separation between the
device and receiver.
• Connect the device into an outlet on a cir-
cuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
20
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1 this device may not cause harmful interfer-
2 this device must accept any interference
FCC RF Radiation Exposure Statement: This
transmitter must not be co-location or operat-
EN 60950/A1,
ing in conjunction with any other antenna or
transmitter. This device complies with FCC RF
radiation exposure limits set forth for an uncon-
trolled environment.
This device should be installed and operated
with a minimum distance of 20 centimetres
between the device and your body.
Canada Regulatory Compliance
This device complies with Industry Canada CAN
ICES-3 (B)/NMB-3(B)
RSS-Gen & RSS-247 statement: This device
complies with Industry Canada RSS standard(s).
Operation is subject to the following two condi-
tions:
1 This device may not cause interference, and
2 This device must accept any interference,
RF Radiation Exposure statement: The device
meets the exemption from the routine evalua-
tion limits in section 2.5 of RSS102 and users can
obtain Canadian information on RF exposure
and compliance.
This device should be installed and operated
with a minimum distance of 7.8 inches
(20 centimetres) between the device and your
body.
ence;
received, including interference that may
cause undesired operation.
including interference that may cause unde-
sired operation of the device.
Philips · PPX5110