Hendi 230695 Mode D'emploi page 8

Troubleshooting
If the appliance does not function properly, please check the below table for the solution. If you are still
unable to solve the problem, please contact the supplier/service provider.
Problems
Machine does not
start running
Machine stops during
operation
Technical specification
Item no.: 230695
Operating voltage and frequency: 220- 240V~ 50/60Hz
Rated input power: 1,680W
Protection class: class I
Waterproof protection class: IP23
Maximum capacity: 2,5L
Dimension: 252x258x(H)547mm
Remark: Technical specification is subjected to change without prior notification.
EN
8
Possible causes
Protective cover (12) is not in properly closed
position.
Jug (9) is not placed properly.
Power switch (1) is not pressed
Built-in overloading device activates.
Possible solution
Check to make sure the protective cover (12)
is closed properly.
Check to make sure the jug set (9) properly.
Press the power switch (1)
- Switch OFF the machine by pressing the
switch (1) to STANDBY mode and unplug the
machine.
- Leaving the machine for cooling down for
about 30 minutes and then start again.
Net weight: approx. 9.7kg
Noise level: approx. 85dB(A)
Rotation speed without loading (rpm):
- Low : 8,350 +/- 10%
- Medium: 13,560 +/- 10%
- High : 24,800 +/- 10%