Position Of The Dispenser And Tank - Toto DSE101EEB Manuel D'installation Et D'utilisation

POSITION OF THE DISPENSER AND TANK

Position of the Dispenser
1. Be sure to leave at least 4-3/4"
(120mm) of space between
the soap dispenser and the
faucet to prevent accidental
activation.
2. Leave 3-1/8"(80mm) of space
maximum from the inside edge
of the sink to the spout installation
hole to ensure that any residual
soap drips from the dispenser
spout into the sink bowl.
Position of the Tank
1. When installing the
controller, make sure
that the tube and cables
can reach the tank.
2. If the tube is too long,
please cut it to suitable length.
Tube length: 17-3/4"(450mm)
Sensor cable length: 19-3/4"(500mm)
Power cord length: 59"(1500mm)
3.Be sure there is adequate space
for refilling/replacing soap tank.
(1) Space between the dispenser and
the faucet to be 4-3/4"(120mm) minimum
Hole for installing the dispenser
[1" ~ 1-3/16" (25~30mm) in diameter]
(2) The distance from the soap
dispenser to the edge of the sink
to be 3-1/8"(80mm) maximum
Auto Soap Dispenser
<4"(100mm)
Tube
6"~12"(150~300mm)
Cover
3-1/2"(90mm)
4
<4"(100mm)
Sensor Cable
Power cord
Tank
Faucet
Sink
<6"(150mm)
Wall Surface
Unit: inches
(mm)
Controller