Sangean RCR-22 Mode D'emploi page 7

Operation
Clock
Automatic clock setting
1. Connect the plug to a wall socket, and your clock radio will
display -:- and the indicator
2. When the radio is off, press and hold Time button
than 4 seconds to receive Auto Time Set signal.
Manual clock setting (only if automatic setting fails)
1. Press the TIME button, and the display will show
2. Press the SET button, and the hour digits will flash on
the display.
3. Press the up or down button to adjust the hours.
4. Then press the SET button, and the minute digits will flash on
the display.
5. Press the up or down button to adjust the minutes.
6. Press SET button to complete the time setting.
* You can also stop the process and save the setting
anytime by pressing TIME button.
Manual date setting (only if automatic setting fails)
1. Press the DATE button then press SET button, the year digits
will flash.
2. Press the up or down button to adjust the year.
3. Press the SET button again and the month digits will flash.
4. Press the up or down button to adjust the month.
5. Press the SET button again and the date digits will flash.
6. Press the up or down button to adjust the date.
7. Preset SET button to complete the time setting.
* You can also stop the process and save the setting anytime
by pressing DATE button.
will flash on the display.
for more
.
GB
6