Oase FiltoClear 5000 Notice D'emploi page 35

Symbols on the unit
Installation and connection
Installing the unit
To be taken into consideration for planning:
 For operation at a swimming pond: Install the unit at a distance of at least 2 m from the water.
 For operation at a pond: You can set up the unit directly at the edge of the pond.
 Protect the pressure filter from direct sunlight.
 Route the return hose into the pond so that the water returns to the pond e.g. through a wa-
ter course. This enriches the water with additional oxygen.
 Ensure that the inlet into the pond is max. 2 m above the filter cover.
Burying the pressure filter
A buried container is barely visible. The stone grey FiltoCap (Art. No. 77831) cover available as an
accessory for the filter cover fits seamlessly into the pond scape.
 Dig a hole close to the pond and place the container in the hole down to the maximum burying
depth.
 The ground must be firm and horizontal.
The unit is dust-proof, fully protected against contact and protected from con-
tinuous immersion in water to a depth of 0.1 m.
Dangerous UVC radiation
Protect the unit from direct sunlight
Protect the unit from freezing temperatures
Do not dispose of the unit with normal household waste
Read the operating instructions
FiltoClear
5000
13000
19000
31000
Burying depth h
0.12 m
0.24 m
0.36 m
0.48 m
EN
35