Battery Installation Direction; Operation Instructions; Temperature Mode Settings - ProfiCare PC-FT 3094 Mode D'emploi

Battery Installation Direction

Temperature Mode Settings

• With the device switched on, press the " Memory / Mode " button for three seconds
until to "F - 1" is shown to enter the long term calibration drift correction mode. On
entering the mode, the previous temperature correction factor will appear on the
the correction mode and press the
and minimize the difference in readings. Repeat and adjust the correction value
as needed until the measurement on the device matches the known temperature.
The mode is applied to Body Temp.
• Press the " Memory / Mode " button a second time "F - 2" shown to set the alarm
temperature limit. Press the
applied to Body Temp.
• Press the " Memory / Mode
button to change the unit.
• Press the " Memory / Mode " button a forth time "F - 4" shown to set the backlit
status. Press the
• Press the " Memory / Mode
Press the or button to switch from ON to OFF.
Notice: Only when the laser head is installed.
Mode Function
Setting devia-
F - 1
tion value
Setting alarm
F - 2
value
PC-FT3094 IM 90x126mm

Operation Instructions

or button to change the correction value
or button to change the value. The mode is
or button to switch from ON to OFF.
" " " "
Increase Decrease
Increase Decrease
Default Remark
Body mode available
Body mode available
Effective Range:
or
67
12.01.21