Table des Matières
Publicité
Installing the sensor
Dimensions
Materials
8
Installation
1
Push the sensor through the armature (pos. 1 in figure 1).
2
Clip the clamping ring (pos. 2 in figure 2) on the sensor cable.
The sharp-edged side of the clamping ring should point to the
armoring (see detail of figure 2).
3
Press the clamping ring together (gap closed), insert it in the
armoring and release it so it clicks into place.
4
Push back the sensor into the armature as far as it will go
(figure 3).
5
Slide the coupling ring (pos. 3 in figure 3) on the sensor and
screw it into the armature by hand.
6
Screw on the protective hood (pos. 4 in figure 3).
Technical data
Diameter
Length (A 325/...)
Length (A 925/...)
Armoring
Clamping ring
Protective hood (A 325/K and A 925/K)
Protective hood (A 325/S and A 925/S)
O-rings ( A 325/... only)
Further accessories
Description
Protective cover for A 325/... and A 925/...
A 325/...; A 925/...
38 mm
200 mm
228 mm
POM
POM
POM
Stainless steel 1.4571
NBR
Model
Order no.
SK-325
201 580
ba75827e02
12/2017
Publicité
Table des Matières
