AEG S63300KDX0 Notice D'utilisation page 30

30 www.aeg.com
Problem
Water flows on the
ground.
The temperature in
the appliance is too
cold.
The temperature in
the appliance is too
warm.
The temperature in
the refrigerator is
too warm.
The appliance does
not operate.
The lamp does not
work.
Door interferes with
ventilation grill.
Misaligned door.
As much as the advice does not lead to result, call the nearest brand-mark service.
7.1 Replacing the lamp
The appliance is equipped with a long-
life LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service
Center .
Possible cause
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The Temperature regula-
tor may be set incorrectly.
The Temperature regula-
tor may be set incorrectly.
The door is not closed
correctly.
The food temperature is
too high.
There is no cold air circu-
lation in the appliance.
Large quantities of food
to be cooled were put in
at the same time.
The appliance is switched
off.
The mains plug is not
connected to the mains
socket correctly.
The appliance has no
power. There is no volt-
age in the mains socket.
The lamp is defective.
The door has been open
to long.
The appliance is not lev-
elled.
The appliance is not lev-
elled.
7.2 Closing the door
1.
2.
Solution
Attach the melting water
outlet to the evaporative
tray.
Set a warmer temperature.
Set a lower temperature.
Refer to "Closing the
door".
Let the food temperature
decrease to room temper-
ature before storage.
Make sure that there is
cold air circulation in the
appliance.
Insert smaller quantities of
food to be cooled at the
same time.
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a another electri-
cal appliance to the mains
socket. Check fuse. Con-
tact a qualified electrician.
Refer to "Replacing the
lamp".
Close the door.
Refer to "Levelling".
Refer to "Levelling".
Clean the door gaskets.
If necessary, adjust the door. Refer
to "Installation".