NEW POL XF71007EL Mode D'emploi page 6

GB
VOCE: Sin centrifugado
550/600 vueltas para un secado basico
700/800/900/1000 vueltas para un secapo super
1100/1200/1300/1400 vueltas para un secado plus
* Values may vary according to the model
The machine offers a wide selection of spin
speeds that can be selected beforehand
according to the wash programme. To change
the spin speed, simply press button ( 2 ) to
select the required speed. The corresponding
speed led will light-up each time the button
is pressed. To exclude the spin, select the
led corresponding to symbol
or the writing "no-spin".
N.B. the maximum spin speed will vary
according to the model and is indicated
by the Leds on the machine. The
maximum spin speed that can be
selected for each programme is
VOCE: El programa se iniciará al cabo de : 1 hora 2 horas, 3 horas, 4 , 5, 6, 7 ,8, 9, 10, 11,12,13,14,
15,16 horas
* Values may vary according to the model
The machine is fitted with a
delayed start function. This allows
the washing machine to be
programmed to start the wash
cycle up to 8 hours later. The delay
VOCE: "Ha iniciado el programa" + (repetir la selección de programa, velocidad, pulsadores ) + beep beep
Press this button to start the wash
cycle. The button (7) to indicate
VOCE: Ha efectuado un reset + beep-beep ( sonido)
The stop function resets the washing
machine. If, for any reason, you want to
change the wash programme or add more
washing to the load during the wash cycle,
simply place the programmer knob in
position "STOP". Then re-position the knob
on the new programme and press the
"START" button.
6
VARIABLE SPIN:
indicated by the leds that light-up
automatically when the wash
programme is selected.
Spin load imbalance control:
This washing machine is equipped
with a special electronic control system
, if present,
for correctly balancing the wash load.
Prior to each spin, the system ensures
that the washing is evenly distributed
in the drum.
If the washing is not evenly distributed,
the final spin speed is reduced, and if
the load is very unbalanced, the spin
is not effected.
DELAYED START:
in hours can be selected as
follows: press the button (1)to set
a delay of 1, 2, 4, 8, hours. Press
START (7). the button (1)
signalling that the function has
START BUTTON:
that the wash cycle has started
PROGRAMMER KNOB "STOP":
Warning!! only use this function if
strictly necessary and then only if
the programme to reset has been
running for a few minutes. Before
opening the door after a reset, wait
2 minutes for the locking mechanism
to release.
Values may vary
according to the
model
2
been activated. The machine will
wait for the number of hours set
to elapse and then start the wash
cycle automatically.
STOP
Centrifugado
Aclarado
En frío
40°
Cotidiano
35°
Rápido
30°
A mano
30°
*1000
*800
*500
3
stop
90°
75°
60°
40°
30°
60°
40°
30°
40°
40°
30°
SM1777