GreenWorks G40LM40 Manuel Opérateur page 6

4. Lift the sides of the lower handle around the edges
of the handle mounting brackets. Do not pinch or
trap the cables.
6 TROUBLESHOOTING
Problem Possible cause
The handle is The bolts are not
not in position. engaged correct-
ly.
The machine The battery ca-
does not start. pacity is low.
The bail switch is
defective.
The battery key
is not put in.
The machine The lawn is
cuts grass un- rough.
evenly.
The blade height
is not set cor-
rectly.
The machine Wet grass clip-
does not mulch pings attach to
correctly. the deck.
The mulch plug
is missing.
The machine is The grass is too
hard to push. tall, or the blade
height is too low.
The grass catch-
er and the blade
drags in thick
grass.
English
Problem
There is a high
vibration in the
machine.
Solution
Adjust the height
of the handle
and make sure
that the knobs
and bolts are
aligned correctly.
Charge the bat-
tery pack.
Replace the bail
switch.
Put in the battery
key.
The machine
Examine the
stops during
mowing area.
mowing.
Move the wheels
to a higher posi-
tion.
Wait until the
grass dries be-
fore mowing.
Install the mulch
plug.
Increase the
blade height.
* If you cannot find the solution to these problems, go to
Empty the grass the service center.
clippings from
7
the grass catch-
er.
Voltage
No load speed
Cut width
Cut height
Grass catcher capacity
Weight (without battery
pack)
Measured sound pressure
level
Measured sound power
level
Guaranteed sound power
level
7
Possible cause
The blade is un-
balanced and
worn.
The engine shaft
is bent.
The blade height
is too low.
The battery pack
is out of power.
The grass clip-
pings attach to
the deck or the
blade.
Operation tem-
perature of the
machine is too
high.
TECHNICAL DATA
40 V
3500 / min
400 mm
20 - 70 mm
50 L
17.12 kg
L = 79 dB(A), K = 3
PA
dB(A)
L = 88.67 dB(A)
WA
L
WA.d
EN
Solution
Replace the
blade.
1. Stop the en-
gine.
2. Remove the
safety key
and battery
pack.
3. Disconnect
the power
source.
4. Inspect for
damage.
5. Repair the
machine be-
fore you start
it again.
Increase the
blade height.
Charge the bat-
tery pack.
Remove the bat-
tery pack and
check the deck.
Cool the ma-
chine.
= 96 dB(A)