Publicité
Les langues disponibles
Les langues disponibles
1
2
3
1. Workpiece
3. View from the top of the
tool
CAUTION:
•
Since excessive cutting may cause overload of the
motor or difficulty in controlling the tool, the depth of
cut should not be more than 3 mm (1/8") at a pass
when cutting grooves. When you wish to cut
grooves more than 3 mm (1/8") deep, make several
passes with progressively deeper bit settings.
NOTE:
•
Moving the tool forward too fast may cause a poor
quality of cut, or damage to the bit or motor. Moving
the tool forward too slowly may burn and mar the
cut. The proper feed rate will depend on the bit size,
the kind of workpiece and depth of cut. Before
beginning the cut on the actual workpiece, it is
advisable to make a sample cut on a piece of scrap
lumber. This will show exactly how the cut will look
as well as enable you to check dimensions.
•
When using the trimmer shoe, the straight guide or
the trimmer guide, be sure to keep it on the right
side in the feed direction. This will help to keep it
flush with the side of the workpiece.
2
1
2
4
4
2. Bit revolving direction
4. Feed direction
001985
1. Feed direction
3
2. Bit revolving
direction
3. Workpiece
4. Straight guide
4
Templet guide
001984
The templet guide provides a sleeve through which the
bit passes, allowing use of the trimmer with templet pat-
terns.
Remove the chip deflector.
Loosen the screws and remove the base protector. Place
the templet guide on the base and replace the base pro-
tector. Then secure the base protector by tightening the
screws.
10mm
(3/8")
1
2
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide slid-
ing along the side of the templet.
1
3
4
5
Straight guide (Accessory)
5
007112
007113
1. Base protector
2. Screw
3. Base
3
003264
1. Bit
2
2. Templet guide
3. Base
4. Templet
5. Workpiece
007109
Publicité
