Operation And Control; Cleaning; Maintenance; Disposal - Baier BSM 287 Traduction Du Mode D'emploi Original

EN
f
4 / 6 BSM 288
The speed can be continuously adjusted
using the adjusting handwheel (2) on the
handle; at maximum speed the handwheel
locks in position.
f
10 / 12 BSM 2842 / BSM 2882
The speed can be continuously adjusted
using the adjusting handwheel (3) on the
motor housing; at maximum speed the
handwheel locks in position.
The pressed ON / OFF switch can be locked
by pressing in the locking device (5).
Select the gear:
f
/ BSM 2863 (110 V / 230 V)
7 9
Set the speed (see technical specifications,
page 27) at the gear change knob (2).
NOTE
Changing gear while the machine is running can
cause damage to the drill.
Wait for the machine to completely stop.
5

Operation and Control

•
Switch on the PRCD switch; only for the
BSM 2863 – 110 V high-speed mixer.
•
Immerse the stirrer in the material to be mixed.
•
Use the ON / OFF switch to start the motor:
f
1 BSM 287, switch ON / OFF Item (6)
f
BSM 288, switch ON / OFF Item (3)
4
f
7 BSM 2863 (110 V / 230 V), ON / OFF
switch Item (3)
f
10 BSM 2842 / BSM 2882, ON / OFF switch
Item (7)
•
In case of low-viscosity media, immerse the
stirrer completely and start.
f Increase the speed if necessary.
•
In case of high-viscosity media, immerse the
stirrer by half and at an angle and start.
f Select a low speed.
•
After ending the mixing process, pull the stirrer
out of the material to be mixed as the stirrer runs
down.
BSM 287
3
•
The toolholder (1) with one annular groove
has a right-hand thread, the toolholder (2) with
two annular grooves has a left-hand thread.
Toolholder (1) is undone counter-clockwise,
toolholder (2) clockwise.
•
You will need an open-ended spanner, A/F22 for
installation / dismantling.
| 30 |
6

Cleaning

DANGER
Risk of injury due to electric shock.
Î Disconnect the mains plug before carrying out
any work on the high-speed mixer.
The machine must be cleaned after each work
session.
•
Carefully clean the machine and blow out with
compressed air.
•
Ensure handles are dry and free from grease.
7

Maintenance

DANGER
Risk of injury due to electric shock.
Î Disconnect the mains plug before carrying out
any work on the high-speed mixer.
The high-speed mixer must be serviced at least
once a year. Further, servicing will be necessary
depending on the wear of the carbon brushes.
Only servicing and repair firms authorised by
Maschinenfabrik OTTO BAIER GmbH may carry
out maintenance of the machine. Also ensure that
original BAIER spare parts and original BAIER
accessories only are used.
8

Disposal

Recycle the machine and its packaging
in an environmentally friendly way in
accordance with the provisions applicable
in your country.